Itoo Software Forum

Author Topic: Clipping issues - stopped working  (Read 916 times)

harumscarum

  • Full Member
  • ***
  • Posts: 113
    • harumscarum's portfolio
Clipping issues - stopped working
« on: June 21, 2017, 01:52:34 PM »
I'm always facing clipping issue when it suddently stopped working and I need to add identical generator and connect same nodes to make it work
I suspect it connected with update of clipping spline because it happen when I edited it

please check attached scene as example


Michal Karmazín

  • iToo Software
  • Hero Member
  • *****
  • Posts: 2447
Re: Clipping issues - stopped working
« Reply #1 on: June 21, 2017, 03:55:33 PM »
Hi,

Big thanks for reporting this problem, it'll need to be investigated more in deep by our main developers. It seems to be tighten to the used Spline > Interpolation - Optimize option (disabling it should help).

Best regards,

iToo

  • Administrator
  • Hero Member
  • *****
  • Posts: 4388
    • iToo Software
Re: Clipping issues - stopped working
« Reply #2 on: June 21, 2017, 06:00:10 PM »
Hi, i could identify the problem: it was caused by a rare bug when using planar segments (no width along the clipping axis).

Try applying some width to the segment's wall, instead using a plane. That should fix the problem.

Anyway the bug is already fixed for the next RC3 update.
Carlos Quintero
iToo Software

harumscarum

  • Full Member
  • ***
  • Posts: 113
    • harumscarum's portfolio
Re: Clipping issues - stopped working
« Reply #3 on: June 21, 2017, 09:01:44 PM »
thank you very much!