Itoo Software Forum

RailClone => RailClone Pro (*) => Topic started by: PR4682 on June 19, 2019, 10:01:18 AM

Title: Complex rooftop
Post by: PR4682 on June 19, 2019, 10:01:18 AM

Hi everyone. Is it possible to be achieved a result similar to the one shown in the image?
Red Arrows are indicating where I need to place a tile with a side finish.
Thank you in advance for any support!

Title: Re: Complex rooftop
Post by: Rokas on June 19, 2019, 11:57:47 AM

You can try to make a side finish with separate Linear RailClone Array and setting to apply it only on some material ID of the spline.

Title: Re: Complex rooftop
Post by: PR4682 on June 19, 2019, 02:12:28 PM

But they will overlap each other causing defects in the render, right?

Title: Re: Complex rooftop
Post by: Rokas on June 19, 2019, 02:31:37 PM

Likely it wont be suitable for close-up render

Title: Re: Complex rooftop
Post by: PR4682 on June 20, 2019, 09:09:57 AM

What would be a good solution in the case where we have a close shot?

Title: Re: Complex rooftop
Post by: Rokas on June 20, 2019, 09:55:08 AM

You could create two splines- one for side tiles and one for main tiles. They can have different sizes. Then use Lonear Array to place Your Perimeter tiles.
You will need to play with Perimterer tiles to align correctly for Your shot.

(https://i.imgur.com/6tDPQ4y.png)