Itoo Software Forum
RailClone => RailClone Pro (*) => Topic started by: georgec on December 20, 2022, 04:51:47 PM
-
See attached. Outside corners of crown moulding not at 90 deg. Having same problem with base mould. Haven't had this issue before.
-
Hi,
As I can see, the Bevel Mode in your scene was set to None - setting it to any other will “enable it”. Also, for this kind of task, you might find a more useful the Scale mode – to keep the poly-count low. Please find the modified scene attached.
I hope that helps.
Best regards,
-
Thank you!