Itoo Software Forum

Author Topic: Closed Ellipse railing  (Read 1188 times)

OU9561

  • Jr. Member
  • **
  • Posts: 52
Closed Ellipse railing
« on: April 07, 2016, 04:07:38 PM »
I have a problem doing a railing on an ellipse. As you can see in the screenshot, the posts are not evenly distributed, no matter what I try there's a gap.
I used one of the railings from the included library, the perforated metal 1.
I tried using the post element in the start / end / start and end of the Linear 1S, but the result is the same.

Thanks a lot!

Michal Karmazín

  • iToo Software
  • Hero Member
  • *****
  • Posts: 2447
Re: Closed Ellipse railing
« Reply #1 on: April 07, 2016, 04:49:10 PM »
Hi,

For those purposes I would suggest you to adjust its Rules in a following way: set the Corner Vertex Type to All & switch Evenly Mode from Distance to Count. Attaching screenshot.

Hope that helps.

Best regards,