Toggle navigation
Login
Register
Itoo Software Forum
»
RailClone
»
RailClone Pro (*)
»
Crash on edit spline L2S generator
« previous
next »
Print
Pages: [
1
]
Author
Topic: Crash on edit spline L2S generator (Read 2586 times)
GT4505
Full Member
Posts: 133
Crash on edit spline L2S generator
«
on:
August 01, 2017, 01:56:26 PM »
Hi,
I've made this rc object with closed splines and an L2S generator in auto align mode.
Not always but quite often when I move some of the splines in edit mode max crashes.
Is this a known issue? Can I prevent it from happening?
Logged
Pieter van Stee
Michal Karmazín
iToo Software
Hero Member
Posts: 2447
Re: Crash on edit spline L2S generator
«
Reply #1 on:
August 01, 2017, 03:19:29 PM »
Hi,
Sorry to hear you're facing these troubles. If you'll be able to reproduce it on a minimal scene, which you can
send us
, it would be great. Thanks in advance for any further comments on this issue you can share about it with us / our user community.
Best regards,
Logged
GT4505
Full Member
Posts: 133
Re: Crash on edit spline L2S generator
«
Reply #2 on:
August 02, 2017, 04:34:53 AM »
Hi Michal,
I will try that later on this week.
It didn't occur every time but usually when dragging rectangles over each other with the spline in edit mode.
Thanks for the reply.
Logged
Pieter van Stee
Print
Pages: [
1
]
« previous
next »
Itoo Software Forum
»
RailClone
»
RailClone Pro (*)
»
Crash on edit spline L2S generator
×
Welcome,Guest
1 Hour
1 Day
1 Week
1 Month
Forever
Login with username, password and session length