Hello,
I'm just getting started with Railclone, and I have a basic question!
I want to space out glazing panels 800mm apart, with sliced panels at the end to fill in the ends. At the moment I'm using the Default node, and this starts the spacing from the start of the spline. When I use Evenly I can't seem to get the ends right. I think I'm missing something obvious, but I'm stuck!
I have attached 2 screen shots. railclone.jpg shows the left glazing as shorter than the others. So ideally this should be cut in half, and it added to the right side (does that make sense?!) Also by doing this the central panel should be central to the smaller returned glazing.
Any help or pointers would be really appreciated!
Thanks,
Dean