Itoo Software Forum

Author Topic: Building  (Read 1011 times)

lebonmarie

  • Newbie
  • *
  • Posts: 32
Building
« on: September 08, 2016, 05:31:59 PM »
Hello,
I would liketo build my building with these parts but when I make my spline it doesn't work well. I  dn't  understand why, my windows are cut ...
How then I to make my roof at the same time?
Thank you very much


https://we.tl/YQIHPSllBo

Paul Roberts

  • iToo Software
  • Hero Member
  • *****
  • Posts: 2991
Re: Building
« Reply #1 on: September 08, 2016, 05:59:49 PM »
Hi,

Thanks for the file. The windows are cut because the generator is using Tile mode . This Mode slices the last segment on the side to fit between the corners.

Instead you could use Adaptive mode which subtly scales the geometry so that only whole segments are used.



I've also slightly adjusted the pivots and padding of the corner segments so that they fit together. Please take a look at the attached file and if you have any questions just let me know.

Cheers!

Paul
Paul Roberts
iToo Software