Itoo Software Forum

Author Topic: default railing woes  (Read 1267 times)

TL1895

  • Sr. Member
  • ****
  • Posts: 396
default railing woes
« on: September 14, 2015, 06:08:51 PM »
Please tell me how I can correct this obvious problem?
Thanks a lot!

TL1895

Paul Roberts

  • iToo Software
  • Hero Member
  • *****
  • Posts: 2991
Re: default railing woes
« Reply #1 on: September 15, 2015, 03:10:04 PM »
Hi,

If you turn on Bend and set the Deform mode to Vertical for hrmetal_start5 and hrmetal_end6 you should find the step is removed.



I hope that helps.

Many thanks,

Paul
Paul Roberts
iToo Software

TL1895

  • Sr. Member
  • ****
  • Posts: 396
Re: default railing woes
« Reply #2 on: September 16, 2015, 11:53:19 AM »
Deadline past, but I will give it a try on the next submission. thank you