Itoo Software Forum

RailClone => RailClone Pro (*) => Topic started by: TL1895 on September 14, 2015, 06:08:51 PM

Title: default railing woes
Post by: TL1895 on September 14, 2015, 06:08:51 PM
Please tell me how I can correct this obvious problem?
Thanks a lot!

TL1895
Title: Re: default railing woes
Post by: Paul Roberts on September 15, 2015, 03:10:04 PM
Hi,

If you turn on Bend and set the Deform mode to Vertical for hrmetal_start5 and hrmetal_end6 you should find the step is removed.

(http://i.imgur.com/uQqCyzz.png)

I hope that helps.

Many thanks,

Paul
Title: Re: default railing woes
Post by: TL1895 on September 16, 2015, 11:53:19 AM
Deadline past, but I will give it a try on the next submission. thank you