Itoo Software Forum

RailClone => RailClone Pro (*) => Topic started by: lukx on June 28, 2013, 09:26:42 AM

Title: density problem
Post by: lukx on June 28, 2013, 09:26:42 AM
here's what I got: (http://clip2net.com/clip/m15854/1372404265-clip-87kb.jpg)
I basically need same spread on the round piece as on the side. How I can achieve it?
Title: Re: density problem
Post by: iToo on June 28, 2013, 09:43:35 AM
Please,  try setting Generator->Y Mode to "Free".

http://www.itoosoft.com/railclone/reference/refgena2s.php#geometry (http://www.itoosoft.com/railclone/reference/refgena2s.php#geometry)
Title: Re: density problem
Post by: lukx on June 28, 2013, 12:18:43 PM
Fantastic! Worked flawlessly ! Thank you Carlos you're life saver !
Title: Re: density problem
Post by: MN4869 on July 23, 2013, 12:36:17 AM
How did you extend the geometry to the other line?
Title: Re: density problem
Post by: iToo on July 23, 2013, 09:06:48 AM
Expanding the size of the array beyond the line and using a Clipping Area:

http://www.itoosoft.com/railclone/reference/refgena2s.php#e (http://www.itoosoft.com/railclone/reference/refgena2s.php#e)