Itoo Software Forum
RailClone => RailClone Pro (*) => Topic started by: Alex.S on March 05, 2020, 09:08:57 AM
-
Usually I just do this by selecting a Vertex Type for the corner which I'm not using, but it's a bit un-intuitive if someone uses my profile and isn't away of this requirement. Is there any chance we could be able to disable it? Whether that just means there is a vertex type disabled mode or something. Would be great. Thanks.
-
Hi, if you doesn't connect any Segment to the Corner slot, and set Bevel mode to "None", the Corner rules are disabled completely.
-
ah ok, thanks, i probably forget to change bevel mode usually