Itoo Software Forum
RailClone => RailClone Pro (*) => Topic started by: hubmer3 on May 31, 2017, 09:04:34 AM
-
Hy!
i use a simple spline for the library preset.
the spline has 4 vertices which are on corner mode!
What is the problem with the mesh?
EDIT: i fixed it by lower the curvesteps in the geometry section from 80 to 5
thx
phil
-
Hi Phil,
Let me add, that's also possible to raise the Corner - Fillet Radius value for the "Sides" Generator to avoid such deformation.
Best regards,
-
Hy!
Thanks, im pretty new to the functionality of RC. I see that i have to raise my skills with the soft ;-)
greets phil