Itoo Software Forum

Author Topic: Segment twist/roll along spline  (Read 711 times)


  • Newbie
  • *
  • Posts: 29
Segment twist/roll along spline
« on: February 08, 2019, 06:59:42 PM »
I think I may have found the answer while searching, but just to confirm. Right now there is no way to stop the segment from twisting or rolling along the spline, correct? For example, I am creating a water park slide and there is a ridge at the sides of the slide tube. This ridge should always be flat to the ground, but in rail clone it rolls and twists as the slide is created along the path.


  • Hero Member
  • *****
  • Posts: 3324
Re: Segment twist/roll along spline
« Reply #1 on: February 11, 2019, 08:24:40 AM »

That is correct. We would like to address that in some future version.