Itoo Software Forum

Author Topic: Extend X/Y  (Read 1161 times)

funk24

  • Newbie
  • *
  • Posts: 15
Extend X/Y
« on: March 14, 2014, 01:41:03 PM »

Hello
sorry for my bad english.
I would like to extend with the x / y function a window with a rectangle.
below should still be a profile that is lower than the rectangle.
now I cut the profile rail clone from.
he gives here a solution?
but it must work with the rectangle.
attached nor a print screen.

Thank you.

Paul Roberts

  • iToo Software
  • Hero Member
  • *****
  • Posts: 1551
Re: Extend X/Y
« Reply #1 on: March 14, 2014, 01:51:41 PM »
    Hi,

    Thanks for getting in touch with us. The clipping path uses a boolean operator to slice any geometry that falls outside the boundary, however it may be overridden. Try the following:

    • For the profile segment, turn off Properties>Deform>Slice
    • In the A2S Generator's properties, set the For No Slice option to Preserve

  • If necessary, set the Profile's generator Default Mode to Scale to prevent a segment from overshooting on the sides.

[/list]

I hope that helps,

Many thanks,

Paul
« Last Edit: March 14, 2014, 02:01:17 PM by Paul Roberts »
Paul Roberts
iToo Software

funk24

  • Newbie
  • *
  • Posts: 15
Re: Extend X/Y
« Reply #2 on: March 14, 2014, 01:58:50 PM »
hi paul

thank you for the quick response!
it works. :)

regards
stefan

Paul Roberts

  • iToo Software
  • Hero Member
  • *****
  • Posts: 1551
Re: Extend X/Y
« Reply #3 on: March 14, 2014, 02:01:58 PM »
Hi Stefan,

Great! Happy to help out  :)

All the best,

Paul
Paul Roberts
iToo Software