Itoo Software Forum

RailClone => RailClone Pro (*) => Topic started by: harumscarum on November 12, 2014, 12:02:58 PM

Title: feature request: advanced Bend mode
Post by: harumscarum on November 12, 2014, 12:02:58 PM
wonder if possible to make Bend mode treat segment as bounding box
i mean that horisontal beams are placed correctly so i want also vertical posts also straighten
or it is possible in any other way?
Title: Re: feature request: advanced Bend mode
Post by: xpp_nd_ruphus on November 12, 2014, 01:36:10 PM
i think you should just correct path
Title: Re: feature request: advanced Bend mode
Post by: Paul Roberts on November 13, 2014, 12:54:09 PM
Hi,

Thanks for bringing this to our attention. We're currently looking into ways RailClone can handle these situations but in the meantime, if your spline is flat on the Z Axis, you should be able to turn Off Properties > Deform > Bend for the fence panel segment. If the slope is gradual you may find turning on Stepped mode is enough to follow the spline. Our libraries suffer from the same problem, these should be fixed too in the next update.

Many thanks,

Paul