Itoo Software Forum
RailClone => RailClone Pro (*) => Topic started by: Sergey_Dobrij on October 27, 2021, 12:52:55 PM
-
Hello! Tell me, how can I fit my object inside the circle or move it in the center ?. To avoid gaps outside. Thanks!
-
Well, depends on how you created the genearator.
Is it A2S with Y mode - free alignment? - enter a negative value for Y size or Reverse the X spline.
Is it A nested L1S? Usually, Transform-Y alignment to Top/Bottom should help.
It is always good to share the scene file because in RC some issues can be solved in multiple ways.
-
Well, depends on how you created the genearator.
Is it A2S with Y mode - free alignment? - enter a negative value for Y size or Reverse the X spline.
Is it A nested L1S? Usually, Transform-Y alignment to Top/Bottom should help.
It is always good to share the scene file because in RC some issues can be solved in multiple ways.
Hi, Dragan!
Scene file
-
Well, depends on how you created the genearator.
Is it A2S with Y mode - free alignment? - enter a negative value for Y size or Reverse the X spline.
Is it A nested L1S? Usually, Transform-Y alignment to Top/Bottom should help.
It is always good to share the scene file because in RC some issues can be solved in multiple ways.
To be honest, I have not yet figured out how to draw splines correctly in Y Spline - Y / Z mode
-
Well, depends on how you created the genearator.
Is it A2S with Y mode - free alignment? - enter a negative value for Y size or Reverse the X spline.
Is it A nested L1S? Usually, Transform-Y alignment to Top/Bottom should help.
It is always good to share the scene file because in RC some issues can be solved in multiple ways.
This can still be solved with padding. But another problem arises. There is an intersection of geometry from the inside
-
Shouldn't the adaptive mode be able to select the most correct result and scale the geometry? As I understand the scale of the geometry from the beginning of the spline X. Do I understand correctly?
-
Sorry for the delay.
You can try nesting two linear generators.
-
Sorry for the delay.
You can try nesting two linear generators.
Thank you friend!