Itoo Software Forum

Author Topic: Railclone not filling out spline...  (Read 435 times)

LC3D

  • Newbie
  • *
  • Posts: 20
Railclone not filling out spline...
« on: July 04, 2022, 04:13:19 AM »
Hey there,

I'm new to Railclone and trying to work out why sometimes RC wont fill out a spline?
See attached image.

The pink spline is one spline - well multiple splines that I've attached to create one spline as you can't have multiple splines/clipping areas for 1 railclone object.
I've tried resetting the x-form and reversing the spline, if I detach the part of the wall that is causing the issue and create a new RC spline then it works fine, but ideally I'd like to have it all attached to one spline as I have a lot of railclone objects in this scene.

I should also mention, this is just the cladding macro, with my own peice of cladding as the geometry/segment.

any advice would be greatly appreciated.

Thanks.
« Last Edit: July 04, 2022, 04:17:07 AM by LC3D »

Paul Roberts

  • iToo Software
  • Hero Member
  • *****
  • Posts: 2991
Re: Railclone not filling out spline...
« Reply #1 on: July 04, 2022, 09:27:07 AM »
Hi,

Thanks for getting in touch. Would you mind uploading that scene so I can take a closer look.

Thanks!
Paul
Paul Roberts
iToo Software