Itoo Software Forum

Author Topic: Clipping area > offset/outline  (Read 358 times)

DT

  • Jr. Member
  • **
  • Posts: 87
Clipping area > offset/outline
« on: December 14, 2022, 04:58:23 PM »
A nice feature to have would be an offset clipping spline parameter. That way we don't have to clone splines and outline them if we want to for instance fill in an area, but have a border around (inside this spline) first. I could think of a few more use cases than this though.

iToo

  • Administrator
  • Hero Member
  • *****
  • Posts: 4388
    • iToo Software
Re: Clipping area > offset/outline
« Reply #1 on: December 16, 2022, 08:39:40 AM »
Thanks for your suggestion.
This is already in the wishlist, although we are thinking a feature with more possibilities for splines, not only offseting. I hope we can implement for next updates.
Carlos Quintero
iToo Software

DT

  • Jr. Member
  • **
  • Posts: 87
Re: Clipping area > offset/outline
« Reply #2 on: December 16, 2022, 11:45:44 AM »
Thanks for your suggestion.
This is already in the wishlist, although we are thinking a feature with more possibilities for splines, not only offseting. I hope we can implement for next updates.

That's nice to hear, the more possibilities, the better :-)