Itoo Software Forum
RailClone => RailClone Pro (*) => Topic started by: iToo_Butler on November 03, 2017, 10:35:57 AM
-
Hi all,
We've been tasked to create this type of wall (see attachment). Not exactly this, but similar in the details.
It's the hexagonal/honeycomb pattern that we need to recreate along a curved wall. So the holes get bigger and small randomly. We've had some decent results using a script to create the hexagons, varying their size with a noise map. The problem with that is the geometry we end up with is terrible and would need a lot of extra cleanup to be usable.
Is it possible to create this type of thing with railclone? W ideally want to do it in a parametric way to make it easy to change in the future if we need to. Any solutions or ideas are welcome.
Thanks in advance.
Andy.
-
a lot of can be taken form this topic:
https://forum.itoosoft.com/railclone-pro-(*)/2d-array-decrease-gradient-density-from-clippingarea-border/ (https://forum.itoosoft.com/railclone-pro-(*)/2d-array-decrease-gradient-density-from-clippingarea-border/)
as i see smaller hexagons are at the edge which is the case of thread above.
Also aproach mentioned here https://forum.itoosoft.com/railclone-pro-(*)/12-running-bond/ (https://forum.itoosoft.com/railclone-pro-(*)/12-running-bond/) probably wil lbe best in Your case.