Itoo Software Forum

« previous next »
Pages: [1]

Author Topic: Array on a curved surface  (Read 750 times)

VanWijnen

  • Newbie
  • *
  • Posts: 40
Array on a curved surface
« on: October 15, 2019, 03:58:01 PM »
Hi,

I've created a RC object that turns a simple rectangle into a brick street. I can't seem to figure out how to use this RC object on the same surface / spline with a slight curve in it. The Linear1S part works just fine but the Array2S not so much. Could you please point out what I'm doing wrong? I've looked at a lot of tutorials and other threads but I couldn't deduce the answer there.
Logged

Dragan

  • Hero Member
  • *****
  • Posts: 1419
Re: Array on a curved surface
« Reply #1 on: October 15, 2019, 04:21:34 PM »
Hi
Try to make the surface slightly larger than the clipping spline.
« Last Edit: October 15, 2019, 04:52:54 PM by Dragan »
Logged

VanWijnen

  • Newbie
  • *
  • Posts: 40
Re: Array on a curved surface
« Reply #2 on: October 16, 2019, 07:22:28 AM »
Hi Dragan,

Thanks for the tip! This does bring me closer but it messes the edges up a bit. Any clue on how to fix that?

(Also, apparently the surface has to be in the same postition as the spline to get the right curve)
Logged

Michal Karmazín

  • iToo Software
  • Hero Member
  • *****
  • Posts: 2477
Re: Array on a curved surface
« Reply #3 on: October 16, 2019, 08:11:20 AM »
Hi,

Raising the Clipping Area > Expand value should fix it.

Best regards,
Logged

VanWijnen

  • Newbie
  • *
  • Posts: 40
Re: Array on a curved surface
« Reply #4 on: October 16, 2019, 08:33:38 AM »
That fixed it Michal, thanks!
Logged
Pages: [1]
« previous next »