I sort of saw this question in the pro version form but did not really see a clear answer. Since we have 5 user license I don't have the info to register in the pro form to post there so I will give it a shot here..
So we basically created a Linear 1S generator and built a simple pole and wire segment and put it along a spline. Wires seg are going into Default, pole seg is going into Evenly. (works great)
My question: Is there a way to slide the entire generator up and down the spline. Problem we have is that the poles are ending up in a middle of a intersection. Our spacing Distance needs to be specific so we can't just adjust that under the Evenly category. Adjusting the end of the spline does seem to move the generator but segments snap on and off adjusting to the length.
We are pretty new to RC so I know this is probably really simple answer, I am just not seeing it or reading it or really know what to ask when searching.
Any suggestions would be great.