Itoo Software Forum

Author Topic: Disable Corner Mode?  (Read 652 times)

Alex.S

  • Full Member
  • ***
  • Posts: 140
Disable Corner Mode?
« on: March 05, 2020, 09:08:57 AM »
Usually I just do this by selecting a Vertex Type for the corner which I'm not using, but it's a bit un-intuitive if someone uses my profile and isn't away of this requirement. Is there any chance we could be able to disable it? Whether that just means there is a vertex type disabled mode or something. Would be great. Thanks.

iToo

  • Administrator
  • Hero Member
  • *****
  • Posts: 4388
    • iToo Software
Re: Disable Corner Mode?
« Reply #1 on: March 06, 2020, 09:44:44 AM »
Hi, if you doesn't connect any Segment to the Corner slot, and set Bevel mode to "None", the Corner rules are disabled completely.
Carlos Quintero
iToo Software

Alex.S

  • Full Member
  • ***
  • Posts: 140
Re: Disable Corner Mode?
« Reply #2 on: March 06, 2020, 03:29:03 PM »
ah ok, thanks, i probably forget to change bevel mode usually