Itoo Software Forum

RailClone => RailClone Pro (*) => Topic started by: Dennis on July 17, 2023, 08:35:54 pm

Title: Increase the size along the line
Post by: Dennis on July 17, 2023, 08:35:54 pm

Hello everyone, I have a doubt on how to accomplish this here:

I have a sidewalk to make where it starts at 200cm wide and then it gets to 300cm. I'm trying to make this transition part smooth, but I'm not getting good results.

I tried to adapt the christmas tree tutorial with scale, but the tiles are stepped and out of paver size. I wonder if anyone has any ideas to enlighten me on this issue.

Thank you very much!

Title: Re: Increase the size along the line
Post by: Paul Roberts on July 18, 2023, 10:01:07 am

Hi,

Thanks for the question. RailClone can't deform geometry to the make the wedge-shaped section you'd need to fill that gap. I'm afraid in this case you would have to model that section and place it using vertices, material IDs or Markers.

I hope that helps,

Paul