Dear Paul Roberts.
thanks for this suggestion.
But i am Sorry to tell you that this workaround still doesnt solve the Problem for me. As you can see in the screencapture picture, in angels greater less than 90 degree you get an Edge segment that doesn´t fill the produced Gap, and in corner angels greater than 90 degree the produced corner segments overlap with the standart segments.
a secound problem that i have found with this stile is the following: When i use the style like a libary style, and start to change my standart segment, like i would in a architektural Bureau, and for example add something to the outside, like a sunshade or when in make the y Depth of the standartsegment greater, the whole edgestructure moves away.
Well the aim for my little Wall-project is the following.
I need a style that other Architekts or architektural visualisation specialists just can open from the libary. They use the outlines of the Floors of the Building as the spline to build from those splines the whole walls to the outside. and... they nearly allways have to change the design of the standartsegments to fit the new ideas of the Architects that devellope those ideas.
So i need a style, where they can change the standart segments without beeing affraid to change the whole logic of the style. Also the style needs to calculate the minmal gap at the corners and fill them automaticaly with a adapted corner segment. (When this would be acheaved i woul add also a Numeric operator that would give me the oportunity to grow all this elements by typing in a certain amount. And later on i could use a conditional operator to change individualy parts of the wall by puting in more vertices on the spline and changing the mat id of a segment)
the only way i can see this could work is a style that doesnt get produced centered on the spline and after this transformed on the y Achsis of the style. But that way do do need a intelligent Script that detects allways the given angel of the corner points, allways reads out the angel and from the given Y width of the corner segments (so i can change the standartsegments without problems), it calculates using tangens , the needed X Szise of the corner segments and also the needed padding of the empty edge segments at the corners.
Well i think this still isnt what works, but i am sure Railclone can do this.