Itoo Software Forum

« previous next »
Pages: 1 [2]

Author Topic: Need some help with Hexagon alignment  (Read 1006 times)

Dragan

  • Hero Member
  • *****
  • Posts: 1419
Re: Need some help with Hexagon alignment
« Reply #15 on: January 05, 2021, 06:03:42 PM »
Glad to help  ;)
Well, the corners are always a little bit tricky. With your pattern, I will probably prepare/remodel separate segments for the corners inputs but then the generator should be based on L1S nested with some A2S/L1S to fill up the default wall surface. Clipped A2S will be hard to track where to finish with the corner and where to finish with the start/end segment.
Logged

IVORM

  • Newbie
  • *
  • Posts: 23
Re: Need some help with Hexagon alignment
« Reply #16 on: January 05, 2021, 08:13:20 PM »
Hi Dragan,

Because I’m still a newbie I find it very helpful reading your solution. Is it also possible to keep both splines separate and adjust the height of one spline with a transform node so the pattern match up?
Logged

Rokas

  • Hero Member
  • *****
  • Posts: 3324
Re: Need some help with Hexagon alignment
« Reply #17 on: January 05, 2021, 08:33:31 PM »
Yes, of course. You can export  X and Y translation parameters and play for each of the spline individually.

Logged
Rokas

IVORM

  • Newbie
  • *
  • Posts: 23
Re: Need some help with Hexagon alignment
« Reply #18 on: January 05, 2021, 08:51:10 PM »
Thks Rokas! You and Dragan are a great help to me. My next question   About facade cladding is on another thread (keeping the forum clean) ;)
Logged
Pages: 1 [2]
« previous next »