Itoo Software Forum

Author Topic: Need to rotate RC 90 degrees  (Read 1770 times)

TL1895

  • Sr. Member
  • ****
  • Posts: 396
Need to rotate RC 90 degrees
« on: February 02, 2016, 03:03:56 PM »
So that it will be vertical, instead of laying flat (as pictured.)

Thanks in advance :)
TL1895

Paul Roberts

  • iToo Software
  • Hero Member
  • *****
  • Posts: 2991
Re: Need to rotate RC 90 degrees
« Reply #1 on: February 02, 2016, 03:19:09 PM »
Hi!

If you're using clipping splines and Extend X/Y size to area the easiest way is to just Rotate the whole RailClone object so that it's local Z axis is pointing towards the wall. There's a section at the bottom of the Clipping Splines chapter of Next Steps with RailClone called "Using Extend X/Y Size to Area to create Vertical styles." that you might find helpful.

Thanks!

Paul
Paul Roberts
iToo Software

TL1895

  • Sr. Member
  • ****
  • Posts: 396
Re: Need to rotate RC 90 degrees
« Reply #2 on: February 02, 2016, 03:47:59 PM »
Thanks Paul, I am relieved that it was something simple!