Itoo Software Forum

« previous next »
Pages: [1]

Author Topic: Normalize Function improvement  (Read 676 times)

QN1156

  • Newbie
  • *
  • Posts: 43
Normalize Function improvement
« on: April 21, 2025, 07:19:51 am »
Can we implement 'Normalize' in the second mode? This will bring more creativity.
Logged

iToo

  • Administrator
  • Hero Member
  • *****
  • Posts: 4666
    • iToo Software
Re: Normalize Function improvement
« Reply #1 on: April 21, 2025, 09:30:05 am »
Please, take a look to the new Connect operator.

It creates the perpendicular lines, as shown in your image.
Logged
Carlos Quintero
iToo Software

QN1156

  • Newbie
  • *
  • Posts: 43
Re: Normalize Function improvement
« Reply #2 on: April 21, 2025, 10:04:45 am »
The new Connect can only implement the first mode, while what I need is the second mode.
Logged

QN1156

  • Newbie
  • *
  • Posts: 43
Re: Normalize Function improvement
« Reply #3 on: April 21, 2025, 10:21:21 am »
The attached.ms file can implement the "Normalize" mode I need. It would be ideal if it could be integrated into the "Normalize" function of RC. Please note that this file, generated by AI and containing Chinese characters, may or may not be of use to you.
Logged

iToo

  • Administrator
  • Hero Member
  • *****
  • Posts: 4666
    • iToo Software
Re: Normalize Function improvement
« Reply #4 on: April 21, 2025, 10:59:28 am »
Thanks, we'll take a look to it.
Logged
Carlos Quintero
iToo Software
Pages: [1]
« previous next »