Hello,
I am wondering if it is possible to have Rail clone use multiple stacked splines as clipping paths. This would allow for creation of varied floor plates for floor slab geometry. See attached file for more info. In the file you will see several spline subobjects that I'd like to use to clip the segment geometry, but Rail Clone only seems to show a boolean addition of the stacked splnes, rather than clipping each layer of the segment geometry defined by each spline subobject. Can this be added? Perhaps a threshold value for adjusting the range of distance from each spline will clip geometry?
See the image attached where the walls follow the splines, but the floors/roof are not clipped per spline.
Thanks.