Itoo Software Forum
RailClone => RailClone Pro (*) => Topic started by: lukx on December 14, 2020, 09:29:35 PM
-
Is it possible to do this kind of string chair back with railclone.
So the strings are getting shorter closer to the arms?
-
Hi.
Have You tried with this technique (https://forum.itoosoft.com/railclone-pro-(*)/looking-for-help-creating-this-pattern/msg22954/#msg22954) already?
I don't know better way for such structure.
-
Thank you Rokas but I can't get the rope to follow the spline(rotating) also top and bottom splines aren't excluded and the scaling of shortest ropes is too flattened.
-
Hi again.
This is my attempt at this chair. Splines used should have some obvious direction so RC can make geometry for them. Otherwise- not possible. As a final tweak You can add FFD on top of RC itself.
(https://i.imgur.com/56qbMeP.png)
Hope this helps at least a bit.
-
Thank you Rokas, looks awesome! What do you mean "Splines used should have some obvious direction so RC can make geometry for them" ?
-
You could not align rc segment because they are too vertical. I have increased the angle they are sloping.
-
Oh, got it, thanks for this tip.