Itoo Software Forum

Author Topic: Offset variation on each floor building  (Read 350 times)

GR4367

  • Newbie
  • *
  • Posts: 12
Offset variation on each floor building
« on: February 01, 2023, 03:06:23 PM »
Hello there,
I´d like to ask how to offset segments on each floor like ref.
Thx a lot!

Michal Karmazín

  • iToo Software
  • Hero Member
  • *****
  • Posts: 2447
Re: Offset variation on each floor building
« Reply #1 on: February 02, 2023, 03:04:48 PM »
Hi,

There are multiple ways how to archive it. A possible style set-up would be to use the Sequence Operator in the Increment at Y mode, where even rows will use "shifted" Segment by the Transform - X Fixed Translation (it can be automatically calculated from the X Size attribute of used Segment). Another option would be to have in the Start slot of the Array 2S Generator the "Full" & "Half" Segments assigned by using a Sequence Operator in the Increment at Y mode.

I hope that helps.

Best regards,

GR4367

  • Newbie
  • *
  • Posts: 12
Re: Offset variation on each floor building
« Reply #2 on: February 02, 2023, 06:15:22 PM »
Hi,

There are multiple ways how to archive it. A possible style set-up would be to use the Sequence Operator in the Increment at Y mode, where even rows will use "shifted" Segment by the Transform - X Fixed Translation (it can be automatically calculated from the X Size attribute of used Segment). Another option would be to have in the Start slot of the Array 2S Generator the "Full" & "Half" Segments assigned by using a Sequence Operator in the Increment at Y mode.

I hope that helps.

Best regards,

Thx Michal, I´ll try.