Itoo Software Forum

Author Topic: One RC for multiple splines  (Read 506 times)


  • Newbie
  • *
  • Posts: 15
One RC for multiple splines
« on: May 24, 2021, 11:51:58 AM »

Is it possible to use one generator for several independant splines? I'd like to avoid copying generators for each spline to have less parameters to click in case of any change. Forgive me if there is already similar topic, but i didn't find it.

Best regards


  • Hero Member
  • *****
  • Posts: 3324
Re: One RC for multiple splines
« Reply #1 on: May 25, 2021, 09:02:02 AM »
Unfortunately that is not yet possible.