Itoo Software Forum

Author Topic: One RC for multiple splines  (Read 79 times)

winoo1

  • Newbie
  • *
  • Posts: 9
One RC for multiple splines
« on: May 24, 2021, 11:51:58 AM »
Hi!

Is it possible to use one generator for several independant splines? I'd like to avoid copying generators for each spline to have less parameters to click in case of any change. Forgive me if there is already similar topic, but i didn't find it.

Best regards
Bartek

Rokas

  • iToo Software
  • Hero Member
  • *****
  • Posts: 3261
    • iToo
Re: One RC for multiple splines
« Reply #1 on: May 25, 2021, 09:02:02 AM »
Unfortunately that is not yet possible.
Rokas
iToo Software