Itoo Software Forum

Author Topic: parametrics windows  (Read 219 times)

RL1396

  • Newbie
  • *
  • Posts: 41
parametrics windows
« on: March 18, 2020, 11:49:14 AM »
Hello,
I have a problem with the parametrics windows. When I copy them and adjust them to the desired dimensions, everything works as it should but if I save, they disappear the project to reveal the letters RC.
Why?
How can I do?

Rokas

  • iToo Software
  • Hero Member
  • *****
  • Posts: 2514
    • iToo
Re: parametrics windows
« Reply #1 on: March 18, 2020, 11:56:15 AM »
Would You please attach or send us Your scene to check it?
Rokas
iToo Software

RL1396

  • Newbie
  • *
  • Posts: 41
Re: parametrics windows
« Reply #2 on: March 18, 2020, 11:58:33 AM »
This is the file

Rokas

  • iToo Software
  • Hero Member
  • *****
  • Posts: 2514
    • iToo
Re: parametrics windows
« Reply #3 on: March 18, 2020, 01:45:36 PM »
Hi
Your file opens fine for me. Only when I clear the Spline from clipping Spline Input, I get these floating RC icons.

Also, upon opening Your file we found that You have been infected with 3dsmax virus.
Please read through this information.
Rokas
iToo Software

RL1396

  • Newbie
  • *
  • Posts: 41
Re: parametrics windows
« Reply #4 on: March 18, 2020, 03:15:11 PM »
Indeed, I had a virus that I was able to remove. Thank you
On the other hand, the problem of parametric windows still exists. I duplicate my pending windows and when I record, the windows disappear and the letters RC appear.
However, at the beginning, everything works as it should. It's just at the time of registration that it happens.

RL1396

  • Newbie
  • *
  • Posts: 41
Re: parametrics windows
« Reply #5 on: March 18, 2020, 04:04:02 PM »
I noticed one thing. If I delete the spline selection in the railclone and select it again. It starts working again. Why? I do not know.

Rokas

  • iToo Software
  • Hero Member
  • *****
  • Posts: 2514
    • iToo
Re: parametrics windows
« Reply #6 on: March 18, 2020, 04:08:27 PM »
Do You use Instance or Copy when copying ?


It does disappear if You use instance. But works fine with Copy.
Rokas
iToo Software

RL1396

  • Newbie
  • *
  • Posts: 41
Re: parametrics windows
« Reply #7 on: March 18, 2020, 04:30:00 PM »
I use instance

Rokas

  • iToo Software
  • Hero Member
  • *****
  • Posts: 2514
    • iToo
Re: parametrics windows
« Reply #8 on: March 18, 2020, 04:55:33 PM »
Use Copy. Instancing mode makes RC share the same clipping spline. Using RC as instance sometimes confuses me. I tend to avoid it.
Rokas
iToo Software

RL1396

  • Newbie
  • *
  • Posts: 41
Re: parametrics windows
« Reply #9 on: March 18, 2020, 05:14:15 PM »
ok. Thank you for the answer.