Itoo Software Forum
RailClone => RailClone Pro (*) => Topic started by: Mattias on October 04, 2019, 12:20:13 PM
-
Hi,
Is it possible to turn off the pattern alignment to the bottom left corner of a spline area (see image) so the pattern stays aligned across multiple spline areas.
kind regards,
Mattias
-
Managed to do it by using forestpack (grid distribution). I`m still curious if this is possible with railclone.
Kind regards,
Mattias
-
Absolutely!
1. Unplug spline node.
2. Disable extended X/Y size to area
3. Enter manually Your dimensions in X and Y parameters
4. Adjust RC object position to Your liking
5. Rewire clipping area
Hope this helps
-
cheers