Itoo Software Forum

RailClone => RailClone Pro (*) => Topic started by: enzo_87 on March 24, 2020, 02:17:16 PM

Title: Pillars/colums
Post by: enzo_87 on March 24, 2020, 02:17:16 PM
Good afternoon everyone.
sorry to bother because of my lack in experience using railclone.

I might need some suggestions/tips...
I'm trying to automate a process for making some structural pillars, I manage to create the pillars itself, but I'm struggling to connect the base to it at the moment.
or actually, I'd like that it stays horizontal. (like the little example in the corner of the image)

Is there any way to make this?
attached also the file if needed to understand better.

Thanks in advance
Title: Re: Pillars/colums
Post by: Rokas on March 24, 2020, 04:20:50 PM
Hi
Thank You for attaching file. To fix this style, I have just set base to be stepped:
(https://i.imgur.com/0RXD6sE.png)

and played with other segments alignment- setting them to Pivot.
Hope this helps.
Title: Re: Pillars/colums
Post by: enzo_87 on March 24, 2020, 04:22:40 PM
thank you very much.
silly me!
I should have think about that soone, like a stairs, thanks so much