Itoo Software Forum

Author Topic: "evenly" piece not displaying  (Read 1098 times)

Macker

  • Full Member
  • ***
  • Posts: 140
"evenly" piece not displaying
« on: November 15, 2019, 12:44:07 PM »
Hi all,

I've got an issue with some glazing I'm making. I't s a pretty simple setup, but I've got an issue where it isn't placing an "x evenly" piece where it ought to, perhaps because it's too close to the bezier corner where the curve begins.

I can rectify this by adding the "evenly" geometry to the "corner" input, however this then gives me a piece of geometry elsewhere where I don't need it. I'm a little perplexed as to how to rectify this. I've attached a screenshot that hopefully helps you understand what I'm talking about.

Michal Karmazín

  • iToo Software
  • Hero Member
  • *****
  • Posts: 2447
Re: "evenly" piece not displaying
« Reply #1 on: November 15, 2019, 02:42:34 PM »
Hi,

As it's really hard to say just from provided screen-shot what might be causing it, would you mind to send us your scene to check it here? Thanks in advance.

Best regards,

Macker

  • Full Member
  • ***
  • Posts: 140
Re: "evenly" piece not displaying
« Reply #2 on: November 15, 2019, 03:56:53 PM »
Hi Michal,

Sure; see attached.


Michal Karmazín

  • iToo Software
  • Hero Member
  • *****
  • Posts: 2447
Re: "evenly" piece not displaying
« Reply #3 on: November 18, 2019, 11:04:11 AM »
Hi,

Setting the Rules > Corner > Bevel Mode to None of the "Velfac Windows" Generator seems to fix it. Please find attached the modified scene. I hope that helps.

Best regards,

Macker

  • Full Member
  • ***
  • Posts: 140
Re: "evenly" piece not displaying
« Reply #4 on: November 19, 2019, 01:24:21 PM »
Perfect, thank you!