I'm trying to setup a panneled wall with railclone, and while I do get somewhere, I can't think of how to make it
exactly as needed.
the thing is, is that either I can get the panels to follow the wall (surface) using an array2s but they all start at the same height, or
I can get them to 'fill' the clippingspline using a lot of vertical splines and a linear1s, but then they won't bend correctly around the curve
coming out the front.
I was hopinh there's a way I can get the array2S to start at varying heights as to fill the area up more nicely.
look at attachement 4. right is the array2s, left the linear1s.
Take special notice of 4th vertical of the 1s. it starts lower than the previous 3 to fille the shape out more nicely. but as you can see on the top of it, the panels
don't curve with the bend of the surface, they only come forward.
the array2s on the right works much better in regard, but lacks the start offsets to better fill out the shape I need.
Any ideas ?