RailClone > RailClone Pro (*)
Rail Road Problem
sg:
Hello. I ran into a proplem while creating railway. The path changes in Z direction and has diffrent turnes. The main problem is unwanted inclination on straight and turn parts of the spline. I used adaptive deformation. Also tried Vertical and Stepped but axes then were straitened along z axis everywhere and didn't conform the direction of the path. Need Help!
iToo:
It should work fine using Bend + Vertical mode. Please, send us a test scene, we'll check it.
sg:
Thanks for fast reply. I've tried to use bend + vertical that partially solved the problem of railways tilt, but they a now deformed too obvious. I've attached the scene.
iToo:
Is there some specific frame in the animation to see the problem clearly ? The path is very long...
By the way: in the wooden generator set "Rules->Corner->Vertex type" to other type than "All" (i.e. Corner or Bezier-Corner). If not, the Corner rule breaks the paths in sections at each vertex, creating strange gaps between the evenly segments. Also i suggest to turn off "Evenly->Justify" (it has no sense here).
sg:
Frame 3839 from Camera_Work. If Bend+Vertical is turned on - axis and rails skew
Navigation
[0] Message Index
[#] Next page
Go to full version