Itoo Software Forum
RailClone => RailClone Pro (*) => Topic started by: Pierre on July 22, 2015, 05:23:26 PM
-
hello,
I'm building walls for a large project and I want to use directly the autocad lines to save time. Unfortunately, the lines are not very accurate which causes the addition of unwanted segment. (see attachment)
I can shorten the line but I have a lot of them...and I can't slice the segment because their lenght must be always the same.
So Is there a way to prevent this?
Thank you
Pierre
-
Hi Pierre,
I assume you're using adaptive mode? If so you can adjust the amount of space required before a new segment is added using the Adaptive Percentage value.
(http://i.imgur.com/wySeHpg.png)
Alternatively you could be more exact by specifying the number of segments using a Material ID applied to the path using this setup
(http://i.imgur.com/QsCfybw.png)
I've attached both approaches in the attached file for you to take a look at.
I hope that helps, please let me know if there's anything else I can do.
Many thanks,
Paul
-
Hi Paul,
I was working with tile because I thougth it was best to preserve the lenght.
I change to adaptative and it's working better.
Thank you very much !
Pierre