RailClone > RailClone Pro (*)
Railclone color not working?
DT:
I have a railclone that scatters 5 vrayproxy cars. The carpaint of all 5 of them is an instanced VrayCarPaintMtl with a Railclone color map with 6 color swatches. Blending mode is set to normal.
For my license plates the same, but with 10 different textures.
Instancing Engine is on and use Segment Material is on.
Problem is there is no randomization at all. All the colors are the same and all the licenseplates are the same. Am I doing something wrong? Do I have to add a special node in my definition?
Thank you.
Paul Roberts:
Hmm,
That's strange. I just did a quick test and RC Colour is working here as expected when scattering V-Ray proxies.
If you can reproduce it with a minimal scene and send it to helpdesk@itoosoft.com I'll take a close look.
Cheers,
Paul
DT:
--- Quote from: Paul Roberts on December 03, 2021, 12:38:18 PM ---Hmm,
That's strange. I just did a quick test and RC Colour is working here as expected when scattering V-Ray proxies.
If you can reproduce it with a minimal scene and send it to helpdesk@itoosoft.com I'll take a close look.
Cheers,
Paul
--- End quote ---
Yeah I find it strange too. I've uploaded the scene to wetransfer. Will send you by email. Thanks.
Paul Roberts:
Thanks for the file. I've taken a look at a single car and it would appear the the paint colour is OK. The variations between them were quire tough to see so I added some more vibrant colours for testing purposes and all seemed OK.
For the number plates on the other hand it would appear the the checkboxes next to the maps were not activated.
Hope that helps,
Paul
RealViz:
I also ran into this behavior once (RCcolor). I think it was because the material was assigned after the RC object was created. However, it was enough to open the scene again. But I don't have confirmation of this.
Navigation
[0] Message Index
[#] Next page
Go to full version