Itoo Software Forum

RailClone => RailClone Pro (*) => Topic started by: LC3D on July 04, 2022, 04:13:19 AM

Title: Railclone not filling out spline...
Post by: LC3D on July 04, 2022, 04:13:19 AM

Hey there,

I'm new to Railclone and trying to work out why sometimes RC wont fill out a spline?
See attached image.

The pink spline is one spline - well multiple splines that I've attached to create one spline as you can't have multiple splines/clipping areas for 1 railclone object.
I've tried resetting the x-form and reversing the spline, if I detach the part of the wall that is causing the issue and create a new RC spline then it works fine, but ideally I'd like to have it all attached to one spline as I have a lot of railclone objects in this scene.

I should also mention, this is just the cladding macro, with my own peice of cladding as the geometry/segment.

any advice would be greatly appreciated.

Thanks.

Title: Re: Railclone not filling out spline...
Post by: Paul Roberts on July 04, 2022, 09:27:07 AM

Hi,

Thanks for getting in touch. Would you mind uploading that scene so I can take a closer look.

Thanks!
Paul