in relation to my other request (and actualy the source of that request) I would love to see an outline / inset modfier/parameter for the spline node.
Specifically when used as clipping area.
I'm building a herringbone with some detailing on the edge (the Red, blue & green parts) and I have controls setup to adjust the width on/off per color.
but the purple is my actual herringbone floor and I would love to use the same spline I used for the L1S generators for the side as clipping area for the A2S I
use for he herringbone. BUT, I would want to drive on offset / outline/ inset on that clip using the same numeric node that's driving the width of the edge detailing area.
Or am i missing some other way to do this ?