Toggle navigation
Login
Register
Itoo Software Forum
»
RailClone
»
RailClone Pro (*)
»
Tiles Alignment New Topic
« previous
next »
Print
Pages: [
1
]
Author
Topic: Tiles Alignment New Topic (Read 303 times)
HU0164
Newbie
Posts: 7
Tiles Alignment New Topic
«
on:
May 07, 2024, 10:15:37 AM »
Hi, I need to use the same Spline to create this type of tiling with plinths where the joints connect.
I asked the question in an old topic and didn't get an answer, so I've created a new topic.
Thank you very much.
Logged
Michal Karmazín
iToo Software
Hero Member
Posts: 2498
Re: Tiles Alignment New Topic
«
Reply #1 on:
May 07, 2024, 10:21:50 AM »
Hi,
If you need precise placement, it's better not to use the "Extend X/Y Size to Area" option. Instead, you can manually position it where you need and then apply the clipping operation separately. To do so:
Enter a value in
Properties
>
Geometry
X Size
and
Y Size
to create an array large enough to cover the area.
Move the RC object over the clipping spline so tiles are positioned where you would like them.
Select the clipping spline from the scene to update the clipping operation.
I hope that helps.
Best regards,
Logged
HU0164
Newbie
Posts: 7
Re: Tiles Alignment New Topic
«
Reply #2 on:
May 07, 2024, 10:26:44 AM »
Thanks for your reply.
I didn't understand everything because I'm new to RailClone but I'll try to understand with your answer and the example provided in the old topic.
Logged
HU0164
Newbie
Posts: 7
Re: Tiles Alignment New Topic
«
Reply #3 on:
May 07, 2024, 12:00:03 PM »
Too complicated for me. I didn't understand the principle despite having deconstructed the example of the old subject.
I'm going to look for another solution.
Logged
Print
Pages: [
1
]
« previous
next »
Itoo Software Forum
»
RailClone
»
RailClone Pro (*)
»
Tiles Alignment New Topic
×
Welcome,Guest
1 Hour
1 Day
1 Week
1 Month
Forever
Login with username, password and session length