Itoo Software Forum

Author Topic: Noob question - Why isn't the default segment aligning properly  (Read 4182 times)

TS4778

  • Newbie
  • *
  • Posts: 1
Noob question - Why isn't the default segment aligning properly
« on: September 12, 2017, 08:53:42 AM »
Trying to create roof tiles with a simple offset, but the segments are not aligning correctly. How can I fix this? I'll post more screenshots of settings if needed

Paul Roberts

  • iToo Software
  • Hero Member
  • *****
  • Posts: 2991
Re: Noob question - Why isn't the default segment aligning properly
« Reply #1 on: September 15, 2017, 01:01:22 PM »
Hi,

Normally I would do this by sequencing a full size then 1.5 size tile in the left and right inputs. Just make sure that you set the sequence operator to Increment on Y.

Attached is a file with a typical setup for this sort of style. I hope that helps, please let me know if you have any further questions.

Many Thanks,

Paul
Paul Roberts
iToo Software