Itoo Software Forum

Author Topic: Railing  (Read 640 times)

EI3056

  • Newbie
  • *
  • Posts: 24
Railing
« on: February 27, 2020, 04:07:49 PM »
Hey,

I´d like to create a railing-style where every side is a closed frame with a small gap between each section.
Anyone can help me figure out how to create this style? (see attached screenshot)

Thanks!

Rokas

  • Hero Member
  • *****
  • Posts: 3324
Re: Railing
« Reply #1 on: February 27, 2020, 04:14:50 PM »
Hi, thanks for sketch. One more detail, what if bend is not 90/270 degrees? let say 45 ?
Rokas

EI3056

  • Newbie
  • *
  • Posts: 24
Re: Railing
« Reply #2 on: February 27, 2020, 04:50:31 PM »
Hey, thanks for your reply!
Good question  :)
I guess the easiest solution would be to continue the railing without a gap right?




Rokas

  • Hero Member
  • *****
  • Posts: 3324
Re: Railing
« Reply #3 on: February 28, 2020, 01:10:29 PM »
Hi
The simplest solution is to break all spline vertices, so each segment is separate spline.



Hope this helps.
« Last Edit: February 28, 2020, 01:15:20 PM by Rokas »
Rokas

EI3056

  • Newbie
  • *
  • Posts: 24
Re: Railing
« Reply #4 on: February 28, 2020, 02:20:03 PM »
Thanks Rokas!