Itoo Software Forum

RailClone => RailClone Pro (*) => Topic started by: EI3056 on February 27, 2020, 04:07:49 PM

Title: Railing
Post by: EI3056 on February 27, 2020, 04:07:49 PM
Hey,

I´d like to create a railing-style where every side is a closed frame with a small gap between each section.
Anyone can help me figure out how to create this style? (see attached screenshot)

Thanks!
Title: Re: Railing
Post by: Rokas on February 27, 2020, 04:14:50 PM
Hi, thanks for sketch. One more detail, what if bend is not 90/270 degrees? let say 45 ?
Title: Re: Railing
Post by: EI3056 on February 27, 2020, 04:50:31 PM
Hey, thanks for your reply!
Good question  :)
I guess the easiest solution would be to continue the railing without a gap right?



Title: Re: Railing
Post by: Rokas on February 28, 2020, 01:10:29 PM
Hi
The simplest solution is to break all spline vertices, so each segment is separate spline.

(https://i.imgur.com/zf4RVxd.png)

Hope this helps.
Title: Re: Railing
Post by: EI3056 on February 28, 2020, 02:20:03 PM
Thanks Rokas!