Itoo Software Forum

Author Topic: Random on,off - switch to custom ?  (Read 393 times)

Joker1979

  • Newbie
  • *
  • Posts: 43
Random on,off - switch to custom ?
« on: October 21, 2022, 11:06:38 AM »
I have a question, is it possible to disable and enable the random modifier so that I can freely set the parameters manually. I attached the file in which I created a node with 3 numeric nodes  but I don't know if it can be connected somehow. I want to have a choice that I can send elements randomly or change to manual and choose the one that suits me. I need it because if I create two separate themes of random and custom building, I will occupy a lot of memory in the project and I would like to do it on one generator.
« Last Edit: October 21, 2022, 11:44:26 AM by Joker1979 »

Dragan

  • Hero Member
  • *****
  • Posts: 1296
Re: Random on,off - switch to custom ?
« Reply #1 on: October 21, 2022, 11:42:17 AM »
Can`t open file due Max`s version.

But, this can be easily done.



Joker1979

  • Newbie
  • *
  • Posts: 43
Re: Random on,off - switch to custom ?
« Reply #2 on: October 21, 2022, 11:45:56 AM »
I have overwritten the file to the 2018 version, you can download it again and see.  But I think what you sent me is what I was talking about thanks  Dragan !!!:)
« Last Edit: October 21, 2022, 11:57:23 AM by Joker1979 »

Michal Karmazín

  • iToo Software
  • Hero Member
  • *****
  • Posts: 1966
Re: Random on,off - switch to custom ?
« Reply #3 on: October 21, 2022, 11:48:38 AM »
Hi,

By right-clicking on the Operator (in your case the UVW XForm Operator) you can choose the Export Parameters and mark the On / Off. Once done you can wire these to the Numeric Operator, which should be set to the Boolean (0/1) Type. I hope that helps.

Best regards,

Joker1979

  • Newbie
  • *
  • Posts: 43
Re: Random on,off - switch to custom ?
« Reply #4 on: October 21, 2022, 03:26:07 PM »
Problem solved. Thanks for advice :)