Itoo Software Forum
RailClone => RailClone Pro (*) => Topic started by: arch3d on July 19, 2022, 01:46:21 PM
-
Hi,
Is it possible to use A1S as hypotenuse segment, or its RC limitation?
It works perfect with regular segments but i would like to avoid messing with Composites
Best
Michal
-
Here is example based on regular segment
-
Hi!
Thanks for the question. It's possible, you just need to tell RailClone which generator in the chain you wish to use for the X Spline Length. You do it like this, using the name of the generator:
(https://i.imgur.com/W0c4GVD.png)
I hope that helps,
Paul
-
So simple! Easier way is always hard to find
Thank you very much:)
-
Paul
Something harder here:)
I put it into markers and have no idea from where is gap
Cheers
-
Please find attached a revised version. I've just tweaked the trig expressions and few other things a little bit.
Hope it helps.
Paul
-
Works perfect
Thank you
-
Paul
I didnt notice it before sorry for that.
What if spline isnt flat?
I have to make a lot of trusses so it seems to be importnant as well.
Only solutution which I can find is make A1S segment verical vithout slope fixing
Cheers
-
Is that solution working well enough? It might be possible to find the angle of the spline, but it could get quite complicated!
Best,
Paul
-
I will see on complex object. It might be ok. If you say its complicated i dont even think about it.
Many thanks its much more better than compose mode ( less distortion in vertical mode
Many thanks
M