Itoo Software Forum

Author Topic: Roof Flashing  (Read 701 times)

XL9177

  • Newbie
  • *
  • Posts: 1
Roof Flashing
« on: November 24, 2021, 06:25:50 PM »
I dont's seem to figure it out.I want to create a roof flashing just like in this image.



I tried splitting the model in 3 different parts but the corners do not change their position correctly and don't seem to get this right.How do I have to split the model at the corners(with the type 1 or type 2 corner)?
At the corners i need that extruded part to be right on the bisector angle.
I used Bevel Corner setting.
Sorry if this is a stupid question but i don't seem to get it maybe because I don't understand the principles on which RailClone works.
Any help would be great.Thank you.



Dragan

  • Hero Member
  • *****
  • Posts: 1419
Re: Roof Flashing
« Reply #1 on: November 24, 2021, 07:30:10 PM »
Hi,
It is not ideal, just basic geometry but it can give you an idea.
I have exposed some parameters for you.
Best Regards

« Last Edit: November 24, 2021, 08:40:13 PM by Dragan »