Itoo Software Forum
RailClone => RailClone Pro (*) => Topic started by: MH4288 on September 04, 2018, 03:06:28 PM
-
Hi,
I have this problem often. Make a rectangle and apply RC on it with some style, but RC rotated wrong. Or its aligned to bottom line and I want to move RC little bit. Is there a way how to do that?
In Floor Generator plugin its really easy to do that. Is there some way please?
Thank you.
-
You can use expand and Z rotation.
Sometimes You will need to add transform operator also.
-
But in complex style, where I have to put it? I will then put it everywhere? Its to complex for just that simple operation I think.
-
It is just another transform operation. Depends on the style. Please attach a style which gives You trouble and we will try to help You.
-
For example Plank Cladding 1 or Cathedral Pantile in Rufing section.
-
Please I need to know how to rotate roof tiles style in 90 degrees.
-
Hi
To rotate style 90 degrees, please do following:
Edit current macro:
(https://i.imgur.com/FmtAr2E.png)
And next step to rotate it 90:
(https://i.imgur.com/dPzOkuN.png)
Hope that helps.
-
Ok, thank you.
And what about moving whole style in rectangle in X or Y please?
-
Sure,
add transform operators, and increase Clipping Area Expand option so mesh is bigger than just clipping area, (not that hard- took about a minute):
(https://i.imgur.com/9lzgSd7.png)
(https://i.imgur.com/7eqlTFD.gif)
Hope that helps
-
I am sorry, but I am not sure what you do here for move in X and Y.
And now I have a problem with a roof style on nonrectangular shape. There is a verge on one side, but its little bit sliced by a spline on that side. And its very hard to move points of spline to exact position so verge is not cropped.
Thank you and sorry for problems.
-
OK, attached a modified macro
Hope that helps
-
Ok, thank you, I will look at it.
And please, is there something I can do to disable slice of verge?
Thank you again.
-
You can adjust this property in segment settings:
(https://i.imgur.com/bQMgSej.png)